Monroe-electronics R189se Manual do Utilizador descarregar pdf (Página 90)

- 85 -

Encoder > General Alerts: Alert Action Table

6.1.1 General EAS

To construct and send an EAS alert, you need to set six items on the General EAS page:

 The EAS alert code;

 The starting time (effective time) of the alert;

 The alert duration

 The FIPS locations codes for the alert;

 The audio message, if any, for the alert.

 The audio announcement message, if any that will precede and follow the alert.

The values for these items are presented using pull-down and selection menus.

Select EAS Code

To set the EAS code, select from the codes presented under the Select Available EAS

Code pull-down menu. The codes shown are the ones that were added to the list on the

Setup >Encoder screen. If the list needs to be corrected, use the link Select Available

EAS Code to return to the Setup > Encoder screen. Configure Available EAS Types for

Encoder as needed. See section 5.9. Then return to the Encoder >Send EAS >General

page to continue constructing the alert.

NOTE: Only specially configured One-Net’s will allow origination of

the National alerts Emergency Action Notification & Termination (EAN

& EAT).

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 113 114

Sem comentários

Monroe-electronics R189se Manual do Utilizador Página 90